Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5510 - redundant interfaces

Hello!

Is it possible to create redundant interface for subinterfaces or is it only available for physical interfaces?

I have one ASA connected to two C3750 which are stacked, and few VLANs that are connected to ASA's subinterfaces via trunk.

Thanks!

Marko

2 REPLIES
Silver

Re: ASA 5510 - redundant interfaces

As soon as you assign a physical interface as a member interface, all the parameters related to that interface will be cleared, including sub interfaces, security level, nameif,etc... However, if you want to configure sub-interfaces (dot1q), you can do

that on top of the redundant interface(s), not the physical interfaces.In other words, member interfaces need to be physical interfaces which cannot have sub-interfaces underneath.

New Member

Re: ASA 5510 - redundant interfaces

Thanks for the information.

Can you tell me how to configure sub-interfaces on top of the redundant interface. I couldn't find any documentation regarding that type of configuration.

That's the main reason why I taught it isn't possible.

Thanks in advance!

Kind regards,

--

Marko

532
Views
0
Helpful
2
Replies