I have to make several changes in the configuration due to our company switching Internet Service Providers. Is it best to do a "show run" at the command line, then just copy/paste new config into the ASA? Or is it better to run the "more system:running-config" command? We don't want to miss anything out of the current configuration. For example; when we run "more system:running-config" it provides config for "asdm location", whereas the "show run" command does not. Please advise! This is a change that is taking place this weekend, so any immediate advice will be greatly appreciated!!!!
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...