Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

ASA 5510 Software upgrade

All,

I have two ASA 5510 with 7.06 sowftware (Security Plus licence), this is the original image the device came with it. When I upgrade to 7.22 the sh ver output says Failover suppport Acitve/Active,while the original image supports Active/Standby and I need Standby option. How can activate Standby option?

Bye

FCS

  • Firewalling
4 REPLIES

Re: ASA 5510 Software upgrade

Silver

Re: ASA 5510 Software upgrade

You dont need to worry about failover support showing "Active/Active", this will still support "Active/Stnadby". Now you just need to make sure that the supposed to be secondary ASA atleast has failover support of "Active/Standby", to configure these ASA's in Active/Standby failover scenario.

Hope this helps.

Regards,

Vibhor.

Silver

Re: ASA 5510 Software upgrade

I use the same 7.2(2) sowftware on 5520 device and it supports A/S, I know that on 5510 there is licencing issue, but why 5510 support A/S with the original image and not with a newer...

That's so strange for me... How can I reach to support 5510 A/S with 7.2(2)

bye

FCS

Silver

Re: ASA 5510 Software upgrade

Hello,

As stated earlier, ASA-5510 does support A/S on 7.2.2. Even if the show version is showing A/A, it means that it can act both as A/A and A/S also.

You can say that A/A is a higher license. A firewall with A/S license cannot work in A/A mode, however a firewall with A/A license can work in both modes, A/A + A/S.

I hope this clears things.

Regards,

Vibhor.

142
Views
4
Helpful
4
Replies
This widget could not be displayed.