Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5520 Configuration Issue

Hi,

My simplified network diagram is attached.

I want access from Site A to site B and vice versa through my ASA.

Both the sites are on the outside interface of ASA. Instead of doing subinterface of the outside is it possible to configure the required routing?

Thanks in adv.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: ASA 5520 Configuration Issue

In the diagram, site A, site B and the ASA are connected to each other via a L2 switch. In such a case you will not need any routing to be configured on ASA so that the traffic can flow between site A and site B. Although you will need routing to be configured on the end routers.

2 REPLIES
Silver

Re: ASA 5520 Configuration Issue

In the diagram, site A, site B and the ASA are connected to each other via a L2 switch. In such a case you will not need any routing to be configured on ASA so that the traffic can flow between site A and site B. Although you will need routing to be configured on the end routers.

New Member

Re: ASA 5520 Configuration Issue

thanks

128
Views
0
Helpful
2
Replies
CreatePlease login to create content