Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5520 Failover (show failover output question)

Hello folks,

this is my ASA 5520 failover output:

This host: Primary - Active

Active time: 1498 (sec)

slot 0: ASA5520 hw/sw rev (2.0/8.2(1)) status (Up Sys)

Interface outside (172.16.1.3): Normal (Waiting)

Interface inside (192.168.1.1): Normal (Waiting)

slot 1: empty

Other host: Secondary - Standby Ready

Active time: 0 (sec)

slot 0: ASA5520 hw/sw rev (1.1/8.2(1)) status (Up Sys)

Interface outside (0.0.0.0): Normal (Waiting)

Interface inside (0.0.0.0): Normal (Waiting)

slot 1: empty

My question is about the IP address shown in standby unit (0.0.0.0) for outside and inside interfaces. This is normal? The standby feature is working properly but this output makes me think about an issue on the failover configuration.

Can someone explain this?

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ASA 5520 Failover (show failover output question)

Do you have standby ip addresses configured?

I.e.

interface

ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2

2 REPLIES
Cisco Employee

Re: ASA 5520 Failover (show failover output question)

Do you have standby ip addresses configured?

I.e.

interface

ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2

New Member

Re: ASA 5520 Failover (show failover output question)

Hi Herbert,

this is the point. I miss this command and after that, the output shown the correct address of standby unit.

Thank you!

Regards,

Rafael.

720
Views
0
Helpful
2
Replies