Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5520 Failover

I have two ASA 5520 appliances running 7.0(4). I use the Management0/0 interface as a connection to the Internet as it is only 100mbps.

That leaves me four Gigabit interfaces to use with DMZ architecture.

I tried to configure active/standby failover using VLAN interfaces on one physical Gigabit interface. The documentation says this is possible and I don't want to burn a whole Gigabit physical interface just on failover -that is an expensive waste of hardware.

The failover confguration would not work despite indentical VLAN interfaces on each member.

Does anybody have any thoughts as to why sub-interfaces, running in isolated VLANs do not work with failover??

Thanks

2 REPLIES
Silver

Re: ASA 5520 Failover

New Member

Re: ASA 5520 Failover

Make sure you haven't named the VLAN-interfaces!

131
Views
0
Helpful
2
Replies
CreatePlease login to create content