Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA 5520 Firewall

I need to remove one NAT which is there, through GUI it wont allow my saying some security rule warning. i also tried to disable security rule and tried but still couldnt do it.

now i was thinking to remove from command line.

the NAT is shown below

static (Inside,Outside) XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX netmask 255.255.255.255

The ip address for Inside, Outside is the same so i was trying to remove it. could any one tell me how can i remove this line from command line??

waiting...

6 REPLIES
Bronze

Re: ASA 5520 Firewall

hello,

on the prompt write

(config)# no static (Inside,Outside) XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX netmask 255.255.255.255

hth, please rate it

Community Member

Re: ASA 5520 Firewall

no static (Inside,Outside) 62.215.215.215 62.215.215.215 netmask 255.255.255.255

^ clear global 62.215.215.215 Local 62.215.215.215

ERROR: % Invalid input detected at '^' marker.

I GET THIS ERROR MESSAGE! PLEASE HELP ON THIS!

Community Member

Re: ASA 5520 Firewall

clear xlate global 62.215.215.215

tried this as well, but

didnt work, doesnt give any error... but when i say

sh xlate

the entry is still there!

do i need to remove NAT before that?

Community Member

Re: ASA 5520 Firewall

any help on this please?

Bronze

Re: ASA 5520 Firewall

hello,

do the above as suggested and reload your firewall.

hth, please rate it

Community Member

Re: ASA 5520 Firewall

doesnt work!! is there any thing else linked with this which i need to delete before i run this command?? i tried to delete xlate before i delete the nat! doesnt work!

148
Views
0
Helpful
6
Replies
CreatePlease to create content