NAT is not required between same security level interfaces even if you enable NAT control. You can optionally configure NAT if desired. However, if you configure dynamic NAT when NAT control is enabled, then NAT is required. See Chapter 27, "Configuring NAT Control," for more information. Also, when you specify a group of IP addresses for dynamic NAT or PAT on a same security interface, then you must perform NAT on that group of addresses when they access any lower or same security level interface (even when NAT control is not enabled). Traffic identified for static NAT is not affected.
•You want traffic to flow freely between all same security interfaces without access lists.
With that said, same security traffic will flow freely wtihout any nat or access-list. If you want to restric this, then you need to change one interface's security level to something else and provide translation just for that one host appropriately. Once done, you can remove the same security command if you do not have any more same security interfaces.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...