We have a requirement, where we need to connect ASA FW to nexus 3064 switch and both nexus and ASA fw should look l2 network. L3 interface connected outside this network. So I have to configure nexus 3064 as l2 switch and ASA fw also as l2 only. Say few vlans 50, 100 should go through firewall via switch and few vlan 200, 250 should go through switch to the server directly. For ex: switch port e1/1 will connect to ASA fw gi0/1 and fw gi0/2 connect back switch e1/2. Need assistance to configure the firewall as layer2. I am attaching the diagram. Please do let me know if need more information.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...