Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA 5525-X Cluster Pool must be configured in this interface error

Hi guys,

I previously have both my ASA 5525-X with cluster configurations. Recently, I decided to remove the cluster configuration and issued a write erase and reload the ASA. However, when Im trying to configure an ip address on any interface it shows the error

"Cluster Pool must be configured in this interface"

I checked the mode, its single and the configuration is clean without cluster configurations.

Please advice on how to solve this issue and your help is much appreciated.

Regards.

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Green

from global config mode,

from global config mode, enter the command:

no cluster interface-mode

let me know how it goes.

 

--

Please rate and select a correct answer

--

Please remember to rate and select a correct answer
2 REPLIES
VIP Green

from global config mode,

from global config mode, enter the command:

no cluster interface-mode

let me know how it goes.

 

--

Please rate and select a correct answer

--

Please remember to rate and select a correct answer
New Member

It works, thanks.

It works, thanks.

1471
Views
5
Helpful
2
Replies
CreatePlease to create content