Our network management system (CA Spectrum) relies on a correctly modelled physical topology in order to find the root cause of a network failure. To accomplish this, we usually model our infrastructure devices (routers, switches) with their management ip addresses and snmp-communities. The physical links between the devices are modelled and the nms can then find the root cause of a network failure.
When it comes to my ASA 5550 active/standby failover cluster, I have not found a way to correctly model my topology, because in case of a failover the boxes switch the active and stanby IP addresses.
The thing I would need, is a possibility to pin an dedicated IP address to the mgmt0 Interface on both devices (one ip on the primary and one ip on the secondary), which do not swap in case of a cluster failover.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...