Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA 5550 port channel

Hi

Is it possible to bundle two ASA interfaces to port-channel interface?

Thanks,

D.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: ASA 5550 port channel

darijohorvat wrote:

Hi

Is it possible to bundle two ASA interfaces to port-channel interface?

Thanks,

D.

D

Not it's not. The ASA does not support etherchannel.

Jon

3 REPLIES
Hall of Fame Super Blue

Re: ASA 5550 port channel

darijohorvat wrote:

Hi

Is it possible to bundle two ASA interfaces to port-channel interface?

Thanks,

D.

D

Not it's not. The ASA does not support etherchannel.

Jon

New Member

Re: ASA 5550 port channel

Thanks!

BR,

D.

New Member

Re: ASA 5550 port channel

Hi darijohorvat

Cisco ASA release 8.4(1) added support for LACP.  EtherChannel is now a support option.

EtherChannel support (ASA 5510 and higher)


You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.


Note You  cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM  in slot 1 on the ASA 5550, as part of an EtherChannel.


We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.

Regards

Donald

4815
Views
1
Helpful
3
Replies
CreatePlease to create content