Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5585 port-channels

I want to create a port-channel with 2 10Gbs interfaces on 2 ASA 5585 firewalls, and set them up in a failover pair.

 

In order to do this, do I simply put two 10Gbs interfaces into a channel and then configure the IP addressing and failover address on the logical port-channel interface? (aka interface po1).

 

Any limitations with this?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Yes, that is exactly what you

Yes, that is exactly what you do..

  1. Create portchannel on switch and ASA
  2. Trunk the vlan on switch side
  3. Create logical interfaces on ASA

 

1 REPLY
New Member

Yes, that is exactly what you

Yes, that is exactly what you do..

  1. Create portchannel on switch and ASA
  2. Trunk the vlan on switch side
  3. Create logical interfaces on ASA

 

190
Views
0
Helpful
1
Replies