Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5585-X IPS SSP system image recovery?

SSP-10 in slot 0

IPS SSP-60 in slot 1

This is not a supported configuration but does it actually work?

On one chassis the system image is missing from IPS SSP-60. I attempted hw-module recovery from tftp but it just gets stuck in recovery mode. IPS SSP console says pretty much says its in boot loop because it does not have a valid image.

The procedure I used

http://www.cisco.com/en/US/docs/security/ips/7.1/installation/guide/hw_system_images.html#wp1371782

I can download the image via tftp to flash but the recovery for IPS SSP just does't load from tftp.

When there are two modules in the chassis, the management port for IPS SSP-60 comes up (green) but I don't see management 1/0 port. Is it still referenced by management 0/0 on IPS SSP console?

203
Views
0
Helpful
0
Replies