Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 8.0(2) do not have traffic shape feature?

Hi there,

Recently I want to apply traffic shape on my ASA5520, but after entering the configure mode of policy-map, I couldnot find the shape command.. If I type the command, the device would notify me that there is no such command.. 

My version is 8.0(2), does anyone of you have idea about this?

PS. Police command is working fine...

Thanks in advance.

Best regards,

Victor

  • Firewalling
5 REPLIES

ASA 8.0(2) do not have traffic shape feature?

I used my favorite search engine and used the text "cisco asa 8.0.(2) configuration guide"

The fourth link was http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/fwmode.html

The 8th chapter down "Applying QoS Policies"

Under "Configuring QoS"

     "Configuring a Service Rule for Traffic Shaping and Hierarchical Priority Queuing"

It took me 2 mins to find this.

HTH>

New Member

ASA 8.0(2) do not have traffic shape feature?

Thanks Andrew,

But how to configure traffic shape is not my problem. My problem is that in my ASA5520, the command 'shape' is 'Unreconginazed command'...

Best regards,

Victor

ASA 8.0(2) do not have traffic shape feature?

So you followed the configuration steps in the document - like below

Step 1

policy-map name

Example:

hostname(config)# policy-map shape_policy

Adds or edits a policy map. This policy map must be different from the hierarchical priority-queuing map.

Step 2

class class-default

Example:

hostname(config-pmap)# class class-default

Identifies all traffic for traffic shaping; you can only use the class-default class map, which is defined as match any, because the security appliance requires all traffic to be matched for traffic shaping.

Step 3

shape average rate [burst_size]

Example:

hostname(config-pmap-c)# shape average 
70000 4000

?????

New Member

ASA 8.0(2) do not have traffic shape feature?

Yes, I followed the guide exactly...

ASA 8.0(2) do not have traffic shape feature?

OK - post the config and any errors you are seeing?

557
Views
0
Helpful
5
Replies