Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 8.0(4) one ACL entry not showing "(htcnt=)"

I have an ACL with two entries, where if I enter "show access-list dmz_in", thoese entries don't have a "(htcnt=)", just the hex entry after. Other ACL lines have (htcnt=0) or (htcnt=12388), etc. Why would those entries not at least show a hit count of 0?

access-list dmz2_in line 7 extended permit udp 10.10.9.0 255.255.255.0 host 172.16.202.161 eq snmptrap (hitcnt=435) 0x6d194893

access-list dmz2_in line 8 extended permit object-group EPO 10.10.9.0 255.255.255.0 host 172.16.202.210 0x5880adba

THANKS!

1 REPLY
New Member

Re: ASA 8.0(4) one ACL entry not showing "(htcnt=)"

Hello!

ASA doesn't show hitcnt in your second line just because the line contains object-group. As far as I know next following line (or perhaps lines) will show real context of the mentioned object group and I hope these lines will show you hitcnt.

With best regards.

145
Views
0
Helpful
1
Replies