Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Asa 9.1.2 udp timeout bug?

After upgrading from 8.4 to 9.1.2 connection numbers are growing and we guess udp connections cannot finalize as usual.

Normal udp timeouts are 2 mins but we have idle udp connections for 10 hours??

Any known bug id or solution?

3 REPLIES
Super Bronze

Asa 9.1.2 udp timeout bug?

Hi,

The Cisco site doesnt seem to list anything specific to your situation

This is the only I found so far

https://tools.cisco.com/bugsearch/bug/CSCuh13899

Are your "timeout" at default for the UDP connections (2min)?

Is there any Policy Map configurations that might affect the timeouts?

Does the idle connection list a non default timeout value when you use the command

show conn long protocol udp

- Jouni

New Member

Re: Asa 9.1.2 udp timeout bug?

Yes 2 min

No policy maps

for below command ,yes lots of

show conn long protocol udp

we normally 500k conns during workhours but after upgrading yesterday this morning now we have 800k conns.

this one exactly the same,we are going to open TAC,i will reply this discussion if we get anything from TAC.

https://supportforums.cisco.com/thread/2045099

New Member

Hi,Did you find out what was

Hi,

Did you find out what was the problem?

Thanks !!

361
Views
0
Helpful
3
Replies
CreatePlease to create content