Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ASA active standby failover if i used only one ip address on interface

ASA active standby failover if i used only one ip address on interface

for example, in outside interface used only active ip address not used standby ip address

but inside interface used both active and standby ip address?

Could this be the issue?

thank.

  • Firewalling
2 REPLIES
Cisco Employee

Re: ASA active standby failover if i used only one ip address on

Hello,

If you are short of IP addresses, you can certainly use IP address only on

the outside interface and not on the secondary (no standby). The only thing

will be that the standby interface would be in "waiting" status. While

outside interface does not have a standby address, you can configure the

inside interface with standby.

Hope this helps.

Regards,

NT

Re: ASA active standby failover if i used only one ip address on

Thank You, Nagaraja

252
Views
0
Helpful
2
Replies
This widget could not be displayed.