You can now configure the ASA to permit or deny VPN connections to mobile devices, enable or disable mobile device access on a per group bases, and gather information about connected mobile devices based on a mobile device's posture data. The following mobile platforms support this capability: AnyConnect for iPhone/iPad/iPod versions 2.5.x and AnyConnect for Android versions 2.4.x.
You would be better of with ASA 8.4 and higher. Yes there is another way of configuring NAT but allot of advanced SSL functions. If you are only using anyconnect and you don't use the SSL VPN you don't have to upgrade. You can stick with 8.2.5. But the devolpements in those train are relatively low. So for now there are only bug fixes in 8.2-X train.
This document is easy to use: Supported VPN platforms.
Thanks to you both I found the answer after digging around the site for a bit. I am thinking about jumping to 8.2 and then sitting on it for a bit because I have to go through my config and get ready for the jump to 8.3 and above. I was told I could jump from 8.0.x to 8.4 directly but that failed in a bad way and I had to roll back.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...