Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA: AnyConnect in Failover Pair

Hi, we have an a/s ASA pair. I noticed that when I upload AnyConnect images to the active unit and deploy them, the standby unit does not receive the changes. I have manually added the images to the secondary's flash filesystem.

Do I need to physically log into the standby unit and configure the images for deployment? I hate making changes directly on the standby unit because of the built-in replication, but this is one instance where I don't think replication actually works. Unless this is by design?

Thanks for any insight.

1 REPLY
Silver

Re: ASA: AnyConnect in Failover Pair

This is by design, copy commands (except copy run start) are not replicated to the standby device.

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/failover.html#wp1091373

HTH.

Regards,

Vibhor.

340
Views
0
Helpful
1
Replies