Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA Basic Configuration

Hi all, I am new to Cisco ASA firewall. I have been trying to make basic configuration in the ASA but dont seem to get it. I cant ping the outside interface from my inside host. I need help on how to setup the ASA and make traffic pass through.

Regards

Xarogo

1 REPLY

ASA Basic Configuration

Hello Samsom,

I cant ping the outside interface from my inside host.

Expected behavior, is well documented that you cannot ping a far-end interface, that means that if you are on a PC on the inside interface you can ping the inside interface IP address but not the ASA outside interface IP address.

You should be able to ping any other device on the outside interface except the ASA outside IP address.

Add this

fixup protocol ICMP

and then try to ping 4.2.2.2 from that inside host.

Also check this my friend (A video that I made on my website)

http://www.laguiadelnetworking.com/video-1-basic-setup-of-an-asa/

Remember to subscribe to my website and rate all of my comments

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
133
Views
0
Helpful
1
Replies
CreatePlease to create content