Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA capture from a context

I have a ASA set up with two context for active active failover. Before this configuration I use to do packet capture on the ASA and transfer them to my computer with the following command:

copy /pcap capture:inside tftp:

Since the context configuration I have not been able to do this. If you are in a non system context you do not get the \pcap or capture options. If I am in the system context, I get the \pcap or the capture options, but this does not work.

Does anyone have a work around for this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ASA capture from a context

Gary,

Use the below format:

copy [/noconfirm] [/pcap] capture: [context_name/]buffer_name url

Regards,

Arul

*Pls rate if it helps*

2 REPLIES
Cisco Employee

Re: ASA capture from a context

Gary,

Use the below format:

copy [/noconfirm] [/pcap] capture: [context_name/]buffer_name url

Regards,

Arul

*Pls rate if it helps*

New Member

Re: ASA capture from a context

Putting in the name of the context was the trick. Works perfect.

155
Views
0
Helpful
2
Replies