Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA config issue

Getting error message "access-list used in static nat has different local addresses" while configuring the static nat statement. But the configuration exists in the running config and the same is working fine. But upon reboot of the device the statemant vanishes. Why is it happenning so?

Thanks

1 REPLY
Cisco Employee

Re: ASA config issue

I am assuming you mean the access-list vanishes after reload. The only time the ACL entry can vanish is when you don't save the configuration. Do you happen to miss saving the configuration prior to reload?

What is configured and what went missing after the reload? and what version of ASA do you have?

159
Views
0
Helpful
1
Replies
CreatePlease to create content