Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA context mode

Hi All

I am trying to change the ASDM listening port number within a context but getting the following error:

DMZwebcon(config)#http server enable 444

                               ^

ERROR: % Invalid Hostname

Is this commad only available in the admin/system context or a software issue???

Any help welcome

Regards MJ

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

ASA context mode

Hi MJ,

Please refer to

http server enable

To enable the adaptive security appliance HTTP server, use the http server enable command in global configuration mode. To disable the HTTP server, use the no form of this command.

http server enable [port]

Syntax Descriptionno http server enable [port]


port

The port to use for HTTP connections. The range is 1-65535. The default port is 443.

Defaults

The HTTP server is disabled.

Command Modes

The following table shows the modes in which you can enter the command:


Command Mode
Firewall Mode
Security Context
Routed
Transparent
Single
Multiple
Context
System

Global configuration

Located at

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/gh.html#wp1781150

Basically, since the VPN functionality is lost when you pass to multiple context, there is no real need to change the default SSL port on the ASA, hence the command  is not supported on that specific mode.

Let me know if you have any further questions.

Mike

Mike
1 REPLY
Cisco Employee

ASA context mode

Hi MJ,

Please refer to

http server enable

To enable the adaptive security appliance HTTP server, use the http server enable command in global configuration mode. To disable the HTTP server, use the no form of this command.

http server enable [port]

Syntax Descriptionno http server enable [port]


port

The port to use for HTTP connections. The range is 1-65535. The default port is 443.

Defaults

The HTTP server is disabled.

Command Modes

The following table shows the modes in which you can enter the command:


Command Mode
Firewall Mode
Security Context
Routed
Transparent
Single
Multiple
Context
System

Global configuration

Located at

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/gh.html#wp1781150

Basically, since the VPN functionality is lost when you pass to multiple context, there is no real need to change the default SSL port on the ASA, hence the command  is not supported on that specific mode.

Let me know if you have any further questions.

Mike

Mike
478
Views
0
Helpful
1
Replies
CreatePlease to create content