Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA CX as Explicit Proxy?

This one should be an easy one, but I haven't found any information on it.

Is there a way to configure the ASA CX as an explicit proxy?  I know that if I want active authentication I can use auth-proxy, and it does work fine, but in this customer's site we're looking forward to replace an existing explicit proxy, without having to reconfigure all the machines to disable it and allow direct connection, leaving the ASA CX to make the http inspection.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

ASA CX as Explicit Proxy?

Hi,

You will not be able to use the CX as an explicit proxy which is one of the functional differences between the CX and the WSA. The CX runs inline, promiscous mode via the service policy for inspection.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
1 REPLY

ASA CX as Explicit Proxy?

Hi,

You will not be able to use the CX as an explicit proxy which is one of the functional differences between the CX and the WSA. The CX runs inline, promiscous mode via the service policy for inspection.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
737
Views
0
Helpful
1
Replies
CreatePlease to create content