Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

ASA - Disable automatic failover

Hey,

I want to use two ASA's as an active/standy cluster in two datacenters. To avoid split-brains I want failover/replication but only switch to the standby unit by hand. My first thought was to disable monitoring on all IF's. Would this be enough?

Thanks

Michael

Michael Please rate all helpful posts
Everyone's tags (4)
2 REPLIES
Bronze

ASA - Disable automatic failover

I think this should work(dont know why you want to do this though), Failover will still happen if the Active unit fails (power, crash, reload or hardware).

Regards,

Felipe.

ASA - Disable automatic failover

Felipe,

Thanks for answer. The reason is thant the units are in separate datacenters and I don't want a split-brain when the line between is down. It's ok for me to failover by hand and not automatic.

Michael

Please rate all helpful posts

Michael Please rate all helpful posts
622
Views
0
Helpful
2
Replies
CreatePlease to create content