Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA EIGRP routing

Hi,

I have an ASA5510 ver8.0(3), its running EIGRP. From the ASA all EIGRP routes/subnets are learned and are pingable. My issue is when I set my PC's default gateway to the ASA inside interface, I'm unable to reach any other subnets or eigrp routes that my ASA could reach.

Any suggestions?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: ASA EIGRP routing

Fred

Are the other subnets reachable via the inside interface ? If so the ASA would need to send the traffic from your PC back out the inside interface and you need to set this up -

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml

Other than that have you

1) checked that what you are trying to ping has routes back to your PC subnet

2) that you are allowing ICMP with access-lists on the relevant interfaces

Jon

1 REPLY
Hall of Fame Super Blue

Re: ASA EIGRP routing

Fred

Are the other subnets reachable via the inside interface ? If so the ASA would need to send the traffic from your PC back out the inside interface and you need to set this up -

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml

Other than that have you

1) checked that what you are trying to ping has routes back to your PC subnet

2) that you are allowing ICMP with access-lists on the relevant interfaces

Jon

245
Views
0
Helpful
1
Replies
CreatePlease to create content