Quick question Is there a way to disable the Slot 1 interface from failover? Specifically I have an ASA Active Standby config with AIP-10's in Slot 1. I would like to keep the failover config but not monitor slot 1.
If both devices are using the IPS services and on the active unit it stops working failover is going to happen, both unit in failover will need to be running the same processes and in this case one will have the AIP-SSM on a good state (Stand by) while the other one will be not responding (Active) therefore failover will occur.
Please rate helpful posts.
Julio Carvajal Senior Network Security and Core Specialist CCIE #42930, 2xCCNP, JNCIP-SEC
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...