Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA Failover

Our primary unit failed over yesterday stating communication failure, but I want to failback. I used the failover active command, but I'm assuming that is not going to work since failover seems to be 'off'.

FW-IN01# sh failover

Failover Off

Failover unit Secondary

Failover LAN Interface: Sync Ethernet0/3 (up)

Unit Poll frequency 1 seconds, holdtime 15 seconds

Interface Poll frequency 5 seconds, holdtime 25 seconds

Interface Policy 1

Monitored Interfaces 3 of 250 maximum

FW-IN01# sh running-config failover

no failover

failover lan unit secondary

failover lan interface Sync Ethernet0/3

failover key *****

failover link Sync Ethernet0/3

failover interface ip Sync 172.16.111.1 255.255.255.0 standby 172.16.111.2

1 REPLY

Re: ASA Failover

Hi,

Try with this command:

failover

I hope this helps.

Best regards.

Massimiliano.

327
Views
0
Helpful
1
Replies
CreatePlease to create content