we are using asa firewall and other end is switch 3750 all the port are gigabit but in firewall all the port are ethernet. in ethernet:speed 100, duplex full..but in switch end: auto is configured...we can configured like this;asa firewall e0/0 speed10, duplex full same as in the switch:g2/0/1:speed 10 duplex full. can we but it will work like half duplex..can any one assist me.
Is there any specific reason why you are trying to set the speed/duplex manually?
Most of the time you should be fine setting both devices port to auto/auto setting. From what I have read on a quick glance setting the values manually/staticly on the device ports might cause problematic situation with some devices.
I usually tend to leave all settings auto, though there are situation where I have manually configured interface for 1000/full for example.
But ok,come to your point only...when we leave both side auto, now it will working as a half duples--->right.
what will happend we configured like this...--->In switch-->Duplex full and in asa firewall--->Duplex full, We are not doing any thing about the speed... we will leave auto...what will be result....????wheather csma/cd will work or not.....?????
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...