Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA in HA (Active/Standby failover) but only one IPS module

Hi folks,

Will I have a chance to configure active/standby failover with a pair of ASAs but only one of them will have AIP-SSM module? I know it is a requirement that the two ASAs are exactly the same from HW and SW perspective, but not sure if that would include IPS module. Obviously IPS will not work if the primary device fails, but that's OK.

Hopefull

Eugene

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: ASA in HA (Active/Standby failover) but only one IPS module

Unfortunately failover would not work with 1 ips module.

Either you should have two,oryou would need to remove one from asa.

Do rate helpful posts.

Regards,

Sushil

1 REPLY
Silver

Re: ASA in HA (Active/Standby failover) but only one IPS module

Unfortunately failover would not work with 1 ips module.

Either you should have two,oryou would need to remove one from asa.

Do rate helpful posts.

Regards,

Sushil

167
Views
0
Helpful
1
Replies