Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA in HA -problem

 

Hi.. i have two ASA 5525 running as Active & failover. I am facing some problen here. When i reboot active ASA then standby become active but when active ASA comes up, it doesnt become active. Standby ASA remains active.

is this default behaviour or there is some config issue.Pls help.

1 ACCEPTED SOLUTION

Accepted Solutions

Hi Anukalp, Yeap. Thats the

Hi Anukalp,

 

Yeap. Thats the default behaviour. If you want to make the primary unit back in to active state.... you have to issue failover reset on active unit to make the actual primary unit to active.

You can go through the below mentioned document which will be helpful for you in configuring failover .

 

http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/77809-pixfailover.html#Shweow

 

HTH

 

Regards

Karthik

2 REPLIES

Hi Anukalp, Yeap. Thats the

Hi Anukalp,

 

Yeap. Thats the default behaviour. If you want to make the primary unit back in to active state.... you have to issue failover reset on active unit to make the actual primary unit to active.

You can go through the below mentioned document which will be helpful for you in configuring failover .

 

http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/77809-pixfailover.html#Shweow

 

HTH

 

Regards

Karthik

Community Member

  Thanks nkarthikeyan...

 

 Thanks nkarthikeyan...

76
Views
0
Helpful
2
Replies
CreatePlease to create content