Hi, I'm setting up my first ASA. I'm able to serial into the device and have setup inside and management interfaces however none of the interfaces are able to establish link state with other devices on the LAN.
The interfaces doesn't appear to be sending out or responding to arp requests. idea's?
Thanks for the reply. I looked in the config and saw that e0/0 was in a shut down state. Trying to remove it wouldn't work so I ran setup again. It removed the shut down state and resolved the linkstate issue.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...