Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA Management interface for Failover

We have been using the management0/0 interface for the failover process with success. I have a co-worker who claims this to not be a good idea. Has anyone heard of any definitive information for or against this practice?

2 REPLIES

Re: ASA Management interface for Failover

Hi Daniel,

In my experience, it is perfectly fine to use the management interface for failover communication. Just be sure to disable management-only mode with the 'no management-only' command on that interface.

Hope that helps.

-Mike

Silver

Re: ASA Management interface for Failover

There is no real difference between the management and normal ethernet interfaces.

196
Views
4
Helpful
2
Replies
CreatePlease to create content