08-01-2012 01:36 PM - edited 03-11-2019 04:37 PM
The management interface needs to be on the same subnet as the inside interface.
Is it possible to specify the management default gateway to the inside ? Will the ASA v 8.0 like this at all ?
The management interface will be remotely manage [from outside] and unfortunately the back end is all layer 2.
route management 0.0.0.0 0.0.0.0 <inside ip address of ASA>
I was also thinking about pointing it to the layer 2 device ( which should have a DG to the ASA inside interface) ...
Thanks,
Pete
Solved! Go to Solution.
08-01-2012 03:40 PM
Hello,
It is not, each interface of the ASA needs to be on it's own broadcast domain ( unless you are running transparent mode)
Regards,
08-01-2012 03:40 PM
Hello,
It is not, each interface of the ASA needs to be on it's own broadcast domain ( unless you are running transparent mode)
Regards,
08-02-2012 07:11 AM
Ok. I guess that makes sense. I thought having the "management-only" command treated the interface differently.
We will have to re-design this somehow.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: