Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA management

When running two ASAs as Active/Standby; is there a way to have two different management addresses using two different networks?

(In a failure each ASA should keep its mgmt address. Basically exclude the mgmt interface from config synchronization.)

Thanks

Joe

4 REPLIES

Re: ASA management

yes you can have both devices on different management address and exclude from failover monitor...But you can only make active configuration chaange on the active device though!

Cisco Employee

Re: ASA management

Hi,

It should be from the same network.

HTH

JK

~Jatin Katyal

Re: ASA management

yep. forgot to mentioned that. thanks JK.

Community Member

Re: ASA management

Would that require using the "standby" ip address on the mgmt interface with two different IPs but on the same subnet?

(I was hoping that the mgt interface config was not "synchronized.)

Thanks

Joe

154
Views
0
Helpful
4
Replies
CreatePlease to create content