i've had a little problem with ASA conf in a multicast environment:
so....sparse mode on all interface involved (routers and ASA) RP is router (are connected with ethernet interfaces ruoters andn ASA and RP in anycast).
with ip pim bidir-enable on ASA i must do igmp static join on router interface towards ASA (source are on another router interface, receiver are on another ASA interface), source-if0-router-if1<igmpstatic>/-if1-ASA-if0-receiver
if i do on ASA 'no ip pim bidir-enable' and i remove on router static igmp all works....i cannot understand why :(:(
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...