Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA NAT Issue

Hi,

 

 

I have a Desktop with ip:10.10.3.4 in my network. In this PC internet working.

 

when i try to add the NAT command in Cisco ASA 5510 -  in this scenario 10.10.3.4 to some public ip X.X.X.X (one to one natting)


static (inside,outside) X.X.X.X 10.10.3.4 netmask 255.255.255.255

Issues are:

1. Internet on this local pc is not working (i.e.., 10.10.3.4)

2. Public ip also not accessable from outside.

 

Thanks for you valuable time and consideration.

4 REPLIES
Community Member

Just a shot in the dark -

Just a shot in the dark - have you added rules to permit the relevant traffic to your host?

Bronze

i believe you have already

i believe you have already the access-group outside inbound. Check the rules and in last case the Logs messages on Firewall because it help always

Community Member

I have already added the

I have already added the rules to permit the relevant traffic to my host.

 

 

how to check the logs messages on firewall?

Bronze

using ASDM:http://www.cisco

using ASDM:

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/113053-asa82-syslog-config-00.html#enablelog

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/113053-asa82-syslog-config-00.html#veri

Using CLI via console/telnet/

Configure the following on the Cisco ASA:

 

ciscoasa(config)#logging monitor 7
ciscoasa(config)#logging console 7
ciscoasa(config)#terminal monitor
ciscoasa(config)#logging on
ciscoasa(config)#logging trap 6
ciscoasa(config)#sh logg

 

 

58
Views
0
Helpful
4
Replies
CreatePlease to create content