Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA NAT problem... help me.

why not nat translation ... i don't understand.. please help me

==== config ====

nat (inside1) 1 10.10.10.0 255.255.255.0

nat (inside2) 1 10.10.11.0 255.255.255.0

global (outside) 1 192.168.1.1-192.168.1.100

some PC not connect to outside network

error message :

portmap translation creation failed

asa or pix bug?

2 REPLIES
New Member

Re: ASA NAT problem... help me.

for the number of nat sources ur pool is very small here u can configured dynamic nat. configure pat by specifying a single ip address.

u can also specify the a single ip address after the gobal pool u have specified.

so once the pool is full then the pix will pat the translations on that single ip.

hope this helps

regards

sebastan

Silver

Re: ASA NAT problem... help me.

Here's what you need-

global (outside) 1 interface

As pointed out by Sebastan, your global pool seems too small to support both inside networks and hence we need to PAT using the above command. Hope that helps.

Regards,

Vibhor.

226
Views
0
Helpful
2
Replies