ASA - OSPF routes Sync issue between Active and standby unit
I'm facing an issue with our ASA 5500. I have configured ASA in Active/Standby mode, but OSPF routes are not getting synchronized to standby unit. Is there any way to have OSPF routes sync between Active and standby unit in ASA 5500.
Re: ASA - OSPF routes Sync issue between Active and standby unit
The only way to reduce the outage is to drop the idea of dynamic routing on the firewall and make it with static routing. On the network components you will have to configure HSRP to make your design fully HA.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...