Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA Question-Help needed

I have configured and integrated an ASA to my network.

Inside----ASA----ROUTER-----Internet

I have 3 servers in my inside network,one of them is a proxy server which all other users use. The 3 servers have both public and private addresses.I have done two layers of nat,one on the ASA and the other on the router.

My inside users cannot ping the inside interface of the router neither can they browse.

I have attached the configs on the ASA and router.

Can someone please take a look at it and let me know where I got it wrong.

5 REPLIES
New Member

Re: ASA Question-Help needed

Some should please help me look into this.

Thanks.

Re: ASA Question-Help needed

Can you post a more complete asa sanatized config to get a better picture and see the nonat acls. You said that your inside users cannot get to the inside interface of the router facing asa outside interface and browse, if this is so you simply need a nat statement.

e.i

your asa already have this statement

global (outside) 1 interface

do you have these ?

nat (inside) 1 0 0

or

nat (inside ) 1

HTH

Jorge

New Member

Re: ASA Question-Help needed

ASA Configs

static(inside,outside) x.x.103.5 x.x.101.5 netmask 255.255.255.255

static(inside,outside) x.x.103.250 x.x.101.250 netmask 255.255.255.255

static(inside,outside) x.x.103.2 x.x.101.2 netmask 255.255.255.255

access-list 100 extended permit icmp any any

access-list 100 extended permit tcp any host x.x.103.5 eq 80

access-list 100 extended permit tcp any host x.x.103.250 eq 80

access-list 100 extended permit tcp any host x.x.103.2 eq 25

int e0/1

access-group 100 in interface outside

access-list NO-NAT extended permit ip x.x.101.0 255.255.255.0 any

nat(inside) 1 access-list NO-NAT

global(outside) 1 interface

route outside 0.0.0.0 0.0.0.0. x.x.103.7

Router Configs

access-list 10 permit x.x.103.0 0.0.0.255

ip nat inside source list 10 interface fa0/0 overlaod

ip nat inside source static tcp x.x.103.5 80 x.x.39.155 80

ip nat inside source static tcp x.x.103.250 80 x.x.39.156 80

ip nat inside source static tcp x.x.103.2 25 x.x.39.73 25

int fa0/0

ip nat outside

int fa0/1

ip nat inside

Re: ASA Question-Help needed

Hi,

Make sure you are not filtering out that traffic on the router by the use of access control lists ..?

I hope it helps .. please rate helpful posts

New Member

Re: ASA Question-Help needed

Hi

You can make the configuration as simple,by controlling all the nat operation at the firewall and allow only routing in the router.It will make as simple the configuration.

Archana.

118
Views
0
Helpful
5
Replies
CreatePlease login to create content