Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA redistribution using route-map

Hello,

I'm trying to accomplish redistribution between two ospf processes using a route-map with an access-list on an ASA.

Can't seem to get it working. Does anyone know if this is possible or if i have something messed up? See below:

redistribute ospf 175 metric-type 1 subnets tag 10457 route-map OSPF175-OSPF100-RMAP

route-map OSPF175-OSPF100-RMAP permit 10

match ip address OSPF175-OSPF100-ACL

access-list OSPF175-OSPF100-ACL remark Used for redistribution

access-list OSPF175-OSPF100-ACL standard permit host x.y.z.0

access-list OSPF175-OSPF100-ACL standard permit host 0.0.0.0

Thank you,

Tom

1 REPLY

Re: ASA redistribution using route-map

Hi Tom

This worked for me, here is my setup

FW0---->(OSPF process 1)FW1(OSPF process 2)---->FW2

FW0 is passing a /32 (192.168.10.1) via OSPF to FW1 process 1 who then redistributes into OSPF process 2 and passes the route onto FW2.

FW1 Config

route-map eigrp_redis permit 10

match ip address eigrp_redist

access-list eigrp_redist standard permit host 192.168.10.1

router ospf 1

network 192.168.1.0 255.255.255.252 area 0

log-adj-changes

!

router ospf 2

network 192.168.2.0 255.255.255.252 area 0

log-adj-changes

redistribute ospf 1 metric-type 1 subnets tag 10457 route-map eigrp_redis

Routing table for FW1

O E1 192.168.10.1 255.255.255.255 [110/11] via 192.168.1.1, 0:04:28, inside

C 192.168.1.0 255.255.255.252 is directly connected, inside

C 192.168.2.0 255.255.255.252 is directly connected, ouside

Routing table for FW2

O E1 192.168.10.1 255.255.255.255 [110/21] via 192.168.2.2, 0:01:34, inside

C 192.168.2.0 255.255.255.252 is directly connected, inside

I am running code 7.2

FW1# sh ver

Cisco PIX Security Appliance Software Version 7.2(2)19

How are your /32 routes begin learned at the point of redistribution ?

214
Views
0
Helpful
1
Replies
CreatePlease login to create content