Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA redundant failover links

Hi,

We are setting up a new ASA which is in multi context mode.  I was wondering if it is possible to setup redundant failover and state links?  I know that it is possible to run failover on one link and state on another, or both over the same link, but is it possible to have both failover and state running on 2 links?  For example, failover and state on ten1/0 as well as failover and state on ten1/1.

Hope I have explained my question well enough.  If not I will try to explain better.

thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

ASA redundant failover links

I would suggest to make a redundant logical link and attach two physical links to it. Than during failover link configuration specify your redundant link as a failover link. Not sure if it works but dont see any obstacles for this solution to fail..

2 REPLIES
New Member

ASA redundant failover links

I would suggest to make a redundant logical link and attach two physical links to it. Than during failover link configuration specify your redundant link as a failover link. Not sure if it works but dont see any obstacles for this solution to fail..

New Member

ASA redundant failover links

Ah, thanks...I had originally tried this but did not find the portchannel as an interface option.  I had overlooked that I had already asigned that portchannel to another context.  Thanks.

899
Views
0
Helpful
2
Replies
CreatePlease to create content