cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2070
Views
0
Helpful
1
Replies

ASA - Scanning Burst Rate

tech_trac
Level 1
Level 1

Hello,

I have configured the burst rate and average rate to 20 and the average drops/sec and current drops/sec is very well below 20. But I still see the trigger count going up with the syslog

message

ASA-4-%733100: [Scanning] drop rate-1 exceeded. Current burst rate is 10 per second, max configured rate is 20; Current average rate is 7 per second, max configured rate is 20;

Cumulative total count is 4667

Why is the syslog message still getting generated. Do I need to restart the ASA for the change in configuration to take effect.

Thanks.

1 Reply 1

Kureli Sankar
Cisco Employee
Cisco Employee

What does "sh run all threat" show? Does it show you the changed value that you configured?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: