02-23-2007 03:53 AM - edited 03-11-2019 02:37 AM
Hi Guys,
Picture the scene, customer has two ASA5510-BUN-K9. They do not have Security Plus license that is required for A/A HA.
In order to enable this, is it simply a software upgrade or is another license required? Seems like a daft question but it's not clear on how to go about obtaining an upgrade license. More likely is just a software upgrade. What do you guys reckon?
Cheers
Ali
02-23-2007 06:53 AM
It is just a license key...it is not a software upgrade. You will run the same software. The part # is ASA5510-SEC-PL.
02-23-2007 07:15 AM
Just out of the question you have asked. A/A is not such a good option do look into its pros and cons and go ahead.
Cheers
Hoogen
02-23-2007 07:25 AM
You only need to upgrade your license. Contact any reseller to purchase the security+ license. As stated earlier, the part no is- ASA5510-SEC-PL and it may cost around USD 1000.
Apart from that, you need to make sure that ASA is running minimum on 7.0.2 code.
Certainly there are few limitations for Active/Acive failover. The requirement is that you need to put your ASAs in multiple-context mode, and limitations under that mode can be found at following link-
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/contexts.htm#wp1116132
Hope this helps.
Regards,
Vibhor
02-26-2007 12:23 AM
Thanks for the help guys
Ali
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide