I've a pair of ASA 5540 used as firewalls. Recently the Secondary unit becomes ACTIVE for unknown reasons. So I apply the CLI "no failover active" to make the Primary active. But a little later, the Secondary appears again active. I did it several times and the issue is still there. Do you guys have met this issue ?
System image file is "disk0:/asa832-k8.bin"
Hardware: ASA5540, 2048 MB RAM, CPU Pentium 4 2000 MHz
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...