Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA_SSL PHONE

Hi

I have the attached configuration, built form all the exmaples I have found.

If I Anyconnect it all works and I can access the network.

However when I load the Cert to the Phone, I am constatntly getting VPN Auth failed.

Is there something I have missed, also every time you change CUCM does the Cert get reload to the Phone ?

Isn't this meant to be easy !!

Thanks

4 REPLIES
Community Member

ASA_SSL PHONE

All fixed

Community Member

ASA_SSL PHONE

All fixed

Cisco Employee

ASA_SSL PHONE

Thanks Ian,

Would you please share with the community your solution.

Mike

Mike
Community Member

ASA_SSL PHONE

Sure, this appeared to be a cache issue, that is the ASA had cached the old Cert.

A reboot of the ASA cleared the issue.

Do you know of a command that does this without the reboot ?

I then hit the phone sending its own Cert and had to enable a Crypt Map to allow a generic look up on the Cert info.

And I am working.

Although the Corp Directory does not work !!

245
Views
5
Helpful
4
Replies
CreatePlease to create content