Hello,
I have an ASA 5505 (128mb flash, 512mb). It was on firmware 8.2.1 so I downloaded 8.4.7 and 9.1.3 and put them in the disk0. I then set the boot image to be 8.4.7 to upgrade to that first and hit reload, but to my shock it started with the 9.1.3 firmware, now it is some sort of loop, see below. Can I power cycle into Rommon mode and change the boot?
Launching BootLoader...
Boot configuration file contains 2 entries.
Loading disk0:/asa913-k8.bin... Booting...
Platform ASA5505
Loading...
IO memory blocks requested from bigphys 32bit: 9956
CISCO SYSTEMS
Embedded BIOS Version 1.0(12)13 08/28/08 15:50:37.45
Low Memory: 632 KB
High Memory: 507 MB
PCI Device Table.
Bus Dev Func VendID DevID Class Irq
00 01 00 1022 2080 Host Bridge
00 01 02 1022 2082 Chipset En/Decrypt 11
00 0C 00 1148 4320 Ethernet 11
00 0D 00 177D 0003 Network En/Decrypt 10
00 0F 00 1022 2090 ISA Bridge
00 0F 02 1022 2092 IDE Controller
00 0F 03 1022 2093 Audio 10
00 0F 04 1022 2094 Serial Bus 9
00 0F 05 1022 2095 Serial Bus 9
Evaluating BIOS Options ...
Launch BIOS Extension to setup ROMMON
Cisco Systems ROMMON Version (1.0(12)13) #0: Thu Aug 28 15:55:27 PDT 2008
Platform ASA5505
Use BREAK or ESC to interrupt boot.
Use SPACE to begin boot immediately.
Launching BootLoader...
Boot configuration file contains 2 entries.
Loading disk0:/asa913-k8.bin...
Thanks
