I would like to find out the right debug command on my case:
ASA 5525X load with 8.6.1 code, the symptom the multiple subinterfaces' i created will went down after certain period of time, with unknown behaviour. There's no physical issue (the cable is fine), so i would like to let the problem simulate again and hopefully can tell from debug log.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...