Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA Switch Ports as Access Ports

I have been reading the ASA Configuration Guide 8.0 and trying to use the command "switchport access vlan 10" under an inteface. Unless I am doing something wrong, why are these commands not available on my device. I'm using Software Version 8.0(4).

1 REPLY
Bronze

Re: ASA Switch Ports as Access Ports

This will work only with ASA 5505, that uses leyer 2 interfaces.

All other ASAs will not acept this command.

IF you are trying to set up a trunk use:

interface eth0/0.10

vlan 10

nameif inside

security.....

107
Views
0
Helpful
1
Replies